PowerFlow ERS MINI, Инструкция по установке и эксплуатации, Страница: 8 / 20

5. Mounting
5.1 Selecting a Suitable Mounting Location
IMPORTANT: E.R.S MINI is rated to IP20. It is suitable for indoor installations only. It is also suitable for
damper environments such as un - heated garages or out buildings. Do not mount sundial in direct sunlight
due to heat absorption. The device will run hotter and become less efficient.
•
The mounting method and location must be suitable for E.R.S MINI ’ s weight and dimensions. It has
been designed for wall mounting only in a near vertical orientation. Ensure suitable ventilation.
•
The mounting location would normally be close to the main consumer distribution board.
•
Only mount on a solid surface and take into account cable runs from the device.
•
The mounting location must at all times be clear and safely accessible without the use of additional
equipment such as scaffolding or lifting platforms. Non - compliance with this recommendation may
restrict servicing.
Extended Mounting Criteria
•
The connection panels must always face horizontally DO NOT MOUNT UPSIDE DOWN!
•
Never mount with a sideways tilt
•
If possible install E.R.S MINI at eye level due to the accessibility of the LED display. If future
service is required, this will also facilitate service work.
IMPORTANT
Temperature Considerations
Do not expose E.R.S MINI to direct sun light, as this can cause excessive internal heating
It is strongly recommended NOT to install E.R.S MINI into loft spaces due to increased heat during
Summer months. Installations in locations which can exceed 40˚C will reduce the ability to
operate efficiently and could reduce the life span of the device. Note: Any manufacturers warranty
will be void if devices are mounted in unsuitable locations.
7
Vertical Mounting Titled backwards no
more than 15˚
Never mount
E.R.S MINI
with a forward tilt
Never mount
E.R.S MINI
Horizontally