www.powerbox-systems.com
9
mission. If a GPS III is connected to the FastTrack input, the Competition also
delivers GPS data to the transmitter.
•
Jeti EX-BUS
One output of the receivers you intend to use must be set to
EX-BUS
. The frame
rate should be set to 10ms, and the Failsafe function must be OFF. If you intend
to use only one receiver, then it must be connected to RX1 to transmit telemetry
data. If a
GPS III
is connected to the FastTrack input, the Competition also deli
-
vers GPS data to the transmitter. Only the REX-Type receivers are supported
•
Futaba S.BUS2
Connect one or two receivers to RX1 and RX2 at the
S.BUS2
output. If only one
receiver is to be used, it must be connected to RX1 to provide telemetry transmis
-
sion. This receiver must also be defined as the telemetry receiver at the transmit
-
ter. In order to receive telemetry data you must carry out a
Load New
process in
the Telemetry Sensor menu; this action completely erases the sensor list. Now
select Slot 16 in the sensor list, and select PowerBox. The telemetry data now
appear in Slot 16 or later. If a
GPS III
is connected to the FastTrack input, the
Competition also delivers GPS data to the transmitter.
•
Spektrum SRXL 2
Connect one or two SPM4651T satellites to the
Royal SR2
using the optional
adapter lead set (#9192). If only one receiver is to be used, it must be connected
to RX1 to provide telemetry transmission. At the transmitter you will now see the
battery data displayed under PowerBox Sensor. If a
GPS III
is connected to the
FastTrack input, the Competition also delivers GPS data to the transmitter.
By default the Competition works in DX18 compatibility mode.
•
Multiplex M-Link
Set the B/D sockets of the receivers you intend to use to SRXL V2. This gives you
sixteen channels. The Failsafe function must be OFF.
To use telemetry you must disable the Telemetry function of one receiver using
Multiplex Launcher. The
Tele
output of the PowerBox should be connected to the
Sensor input of the other receiver.
Note:
do not attempt to register the
PowerBox
as a sensor at the transmitter;
this function is not implemented.
