www.powerbox-systems.com
27
When the positions are being established you will see that the wheel doors and
the undercarriage itself always follow the cursor position, and slowly approach
the set position. If you wish to adjust these positions, press the SET button and
make changes using buttons I and II. Select
Finished
to adjust the other wheel
doors. Once all the doors are correctly adjusted, the following display appears,
and you may be asked to move the retract switch to
Extended
:
The Assistant now opens all the wheel doors and moves the undercarriage to the
Extended
position. At this point you can check the operation of the sequencer by
operating the retract switch on the transmitter. If you find a problem - perhaps
the pause between the undercarriage and the wheel doors is too short - you just
select the Assistant again, and change the appropriate setting. There is no need
to re-adjust the wheel door positions.
Should you wish to set up additional wheel doors or travel points, you can do this
at any time in
Manual Setup
.
Note:
it is important to keep to the standard sequence when installing the
Royal SR2
for the first time:
Setup Assistant
(basic setup) –>
Sequencer Assistant
–> manual output as
-
signment of all other functions.
If you ignore this, the Sequencer Assistant could overwrite
Direct
functions
which are already assigned.
