2.5 Operation
1. Switch on the machine.
2. Use lever (Fig5/4) to lower
squeegee. Vacuum motor switches
on automatically.
3. Use solution control (Fig5/3) to set
the desired flow rate.
4. Use pedal (Fig5/1) to lower brush
deck. The solution supply switches on
automatically.
Start moving machine immediately
after switching on the brush deck,
otherwise the brushes leave traces on the
floor. Lift brush deck before passing over
steps and other obstacles.
2.6 Stop Machine
When the bail handle is released it au-
tomatically returns to the neutral position.
The machine stops. Secure the machine
against unintentional movements or
against being started.
2.7 After Work
1. Move machine to a suitable site for
maintenance.
2. Stop machine, lift squeegee and brush
deck and remove the key.
3. Empty and clean recovery tank.
Observe the legal directives and local
regulations for disposal of detergents. 4.
Check solution filter.
5. Check seals and suction hose.
6. Check operating fluid levels, function and
setting.
7. Charge batteries.
8. Clean the machine. Empty the solution tank before shutting
down the machine for a longer time.
Do not clean the electrical parts by
means of high-pressure cleaning
equipment.
2.8 Transporting the machine
To transport the machine to the work area,
switch it on, lift-out squeegee and brush
deck, pull the bail handle start movement.
2.9 Tie-down points
IWhen transporting on a vehicle or trailer,
the machine has to be secured. Tie the
machine down firmly by using the front eye
bolts (Fig. 2/1) and the rear chassis (Fig.
2/2) as tie-down points.
5. Use speed control knob (Fig.4/9b) to
adjust work speed. Use the direction
switch (Fig.4/9a) to select forward or
reverse. Pull the bail handle (Fig.4/ 9c) to
start moving.
Fig.2
