PowerBoss armadillo 10x series, Руководство пользователя

Страница: 42 / 70

PowerBoss, Inc.
Copyright 2008
Armadillo
®
SW/10XV PB # 4100034 / Rev. 01A08
Page 40
Operation, Maintenance and Troubleshooting
S E R V I C E I N S T R U C T I O N S ( C O N T I N U E D )
S W E E P C O M P O N E N T S ( C O N T I N U E D )
MAIN BROOM TAPER ADJUSTMENT
It is not usually necessary to perform this adjustment. However, if the
main broom adjustment test shows a pattern that is tapered in length (one
end is wider than the other), perform the procedures which follow.
Correct Taper Pattern
Incorrect Taper Pattern
Main Broom Taper Patterns
1. Locate the adjusting screws directly beneath the hydraulic pump.
2. Loosen the jam juts on the adjusting screws, and loosen the retaining bolt on the
inside of the mounting bracket.
3. Use the adjusting screws to raise or lower the left end of the main broom. (The
right end of the broom remains fixed. All adjustments affect the left end of the
broom.)
4. After adjustment, tighten the retainer bolt and adjusting screws.
5. Repeat the main broom adjustment test to see that the broom is properly adjusted.
NOTE