PowerBoss armadillo 10x series, Руководство пользователя

Страница: 51 / 70

PowerBoss, Inc.
Copyright 2008
Armadillo
®
SW/10XV PB # 4100034 / Rev. 01A08
Page 49
Operation, Maintenance and Troubleshooting
Normal adjustment of the parking brake can be accomplished from the operator compartment. Lo-
cate the knurled handle on the parking brake lever. Turn the handle clockwise to increase brake ten-
sion.
Two or three turns is usually adequate. DO NOT OVERTIGHTEN.
If this adjustment becomes ineffective, it will be necessary to adjust the cable length.
Do not rely upon the hydraulic cylinders to keep the hopper raised
for maintenance. Always engage the safety arm before servicing
in the area of the hopper.
ADJUSTING THE PARKING BRAKE CABLE LENGTH
1. Park the machine on a level surface and chock the wheels.
2. Place the parking brake lever in the “OFF” position.
3. Turn the knurled handle counter-clockwise as far as possible.
4. Raise the hopper and engage the safety arm.
5. Locate the cable clevis ends for the parking brake cables.
6. Disconnect the clevis ends from the bar.
7. Loosen the jam nuts at the base of the clevis.
8. Turn the clevis clockwise three or four complete turns.
9. Tighten the jam nuts and re-install the clevis ends onto the bar.
10. Adjust the knurled handle on the parking brake lever.
S E R V I C E I N S T R U C T I O N S ( C O N T I N U E D )
PA R K I N G B R A K E
NOTE
WARNING