PowerBass XTA 2160, Руководство пользователя, Страница: 7 / 24

CONTROL PANEL LAYOUT
1. LINE OUT (RCA) JACKS
RCA style output jacks allow for unfiltered signal to be sent to other amplifiers or processors. Only one Remote
Gain Control can be used when multiple bass amplifiers are connected.
2. LINE IN (RCA) JACKS
The RCA style input jacks are for use with source units that have RCA line level outputs. A source unit with a
minimum of 250mV is required for proper operation. However, this input will accept levels up to 6Vrms.
3. GAIN Control
This control is used to match the input sensitivity of the amplifier to the particular source unit that you are
using.
4. BASS EQ Control
This equalization circuit is used to enhance the low frequency response of the vehicle’s interior. With up to
18dB of boost centered at 45Hz, the BASS EQ can be adjusted to meet your own personal taste.
Fig.2 Panel Layout
For XTA 4140
7
14
CH1
CH2
CH3
CH4
FRONT
L
R
REAR
LINE IN CH 1/2
CH 3/4
LINE OUT
X-OVER
HPF LPF
FULL
INPUT
MODE
CH2 CH4
HPF LPF
FULL
MIN MAX
GAIN BASS EQ HPF
0dB 18dB 80Hz 1.5kHz
MIN MAX 0dB 18dB 80Hz 1.5kHz
40Hz 500Hz
LPF
40Hz 500Hz
1
12
13
2
3
4
5
6
7
9
8
10
11
MIN MAX
L L
GAIN
LINE OUT LINE IN
BASS EQ HPF
R R
0dB 18dB 80Hz 1.5kHz
40Hz 500Hz
X-OVER LPF
HPF LPF
FULL
POWER
STATUS
POWER SPEAKER OUTPUT
FUSE
GND REM BATT+
BRIDGED
CH1 CH2
XTA2160
30A