REM (Remote)
This terminal must be connected to a sw12V source. Typically, remote turn-on leads are provided at
the source unit that will turn on and off the amplifier in correspondence with the source. If the source unit does
not have a remote turn-on lead, then a power antenna wire can be used. If neither of these leads is available
at the source unit, then a sw12V supply must be used, like the ACC, +12V.
Run a minimum of 18 gauge wire from the amplifier location to the source of the sw12V lead. If pos-
sible, route this wire on the same side of the vehicle as your power cable. Connect the source remote output
to the wire. Go back to the amplifier and cut the wire to length. Loosen the screw terminal marked REMOTE
on the amplifier using a Philips (cross) type screwdriver. Insert the stripped (bare) portion of the wire into the
terminal and tighten the screw securely
11