TECHNICAL FEATURES
•
Low Profile Finned High Density Aluminum Alloy Heatsink
•
4-Layer Double Sided Circuit Board Construction
•
PWM MOSFET Power Supply for high power output and best stability into low impedance loads
•
Variable High Pass and Low Pass Electronic Crossover
•
Soft Delay Remote Turn On/Off System for eliminating pop noises
•
Adjustable Bass EQ at 45Hz (18dB)
•
Self Diagnostic Multi Protection Circuit with LED Indicator for; Impedance Over-load, Speaker Short
Circuit, Thermal Overheating, and DC Output.
•
2-ohm Stereo (4-ohm Mono Bridgeable)
•
Custom Tooled Speaker and Power Terminal Blocks
•
Variable Gain Control
•
Low Level Line Inputs and Outputs
•
Blue Power-on Edge-lit PowerBass Logo
INSTALLATION EXPERIENCE
Installation of PowerBass mobile amplifiers requires detailed knowledge of electronics wiring and proper
speaker impedance. We strongly recommend installation by an authorized PowerBass Xtreme dealer. This
Owners Manual only provides general installation and operation instructions. If you have any reservations
about your installation skills, please contact your local PowerBass dealer for assistance.
PREPARING FOR INSTALLATION
NOTE:
The tools listed below may be required for basic installation
•
An electric drill with bits
•
Philips head and standard screwdrivers
•
Wire strippers
•
Crimping tool
•
VOM (electronic volt ohm meter)
•
Heat shrink tubing and heat gun
•
Soldering iron
INSTALLATION PRECAUTIONS
NOTE:
Proceed only if you are a qualified installer otherwise, let your dealer do it. Always wear protec-
tive eyewear when using tools.
•
Turn off all stereo and other electrical devices before you begin.
•
Disconnect the negative (-) lead from your vehicles battery.
•
Locate all fuel lines, brake lines, oil lines, and electrical cables when planning the install.
•
Make sure there is at least 2-inches (5 cm) around the air vents on the amplifier.