Walls
1.
Please ensure you have removed the transport blocks as per page 6.
2.
Your shed will come with a number of wall sections. The quantity of these will depend which size you
ordered. Please see the components table to confirm which panels you should have for your Power Pent
Bike Shed.
3.
Start with the 2ft panel that will be part of your 6ft wall
–
position this on top of the floor panel. Ensure
the side of the panel is flush with outer edge of floor (but not overlapping the heavy duty bearer on the
6x5 and 6x6). Then position one of the gable end panels at the end (sitting on the bearer for the 6x5 and
6x6 sizes) and secure these panels together from the inside using the 50mm screws provided. Use three
screws per join.
Note
- For 6x5 and 6x6 models the ends of the shed will come in more than one section.
It does not matter which of these goes to the front and back.
Important
!
When securing panels together ensure they line up at the top (so the building is square) and that only the ends
of the cladding are shown, which will later be covered with corner strips).
This is only in the corner when the side meets the gable.
4.
Place the remaining 4ft back wall panel and then the other 2ft / 3ft / 4ft end wall panels and again secure
using the 50mm screws provided.
Page 8 of 18