Floor
1.
Lay down your floor panel(s) onto your firm and level base into the desired position of your shed.
Be sure to consider any overhangs on the shed when deciding the correct position as per the instructions
regarding bases in the ‘before you start’ section.
NOTE: Do not confuse floor panels with roof panels.
Floor panels will have more pieces of framing attached.
2.
For the 6x5 and 6x6 sizes, the floor will be in two sections.
Turn the floor sections upside down so that the floor bearers are facing up. Join the floor panels together
using the 50mm screws provided. You can then turn the floor back the right way to create the full floor.
For 6x2, 6x3 and 6x4 sheds, the floor panel is in one piece.
3.
Screw the two ‘heavy duty bearers’ which are two pieces of
framing joined together, to the two ends of
the shed with 70mm screws. This will cover the ends of the floor joists. On our 6x2, 6x3 and 6x4 sizes the
bearers will need to run the 6ft length, on our 6x5 and 6x6 sizes the bearers will fix to the gable end as
pictured below.
USEFUL TIP!
–
If you have purchased a POWER Base you can screw the floor to the timber POWER base
below for maximum strength and security.
Reminder
Ensure bearers are
added to the floor!
Page 7 of 18