Power Stroke PS907000S, Руководство оператора

Страница: 21 / 48

Page 17 — English
SPARK ARRESTOR
See Figure 19.
NOTICE:
This product is equipped with a spark arrestor that has
been evaluated by the USDA Forest Service; however,
product users must comply with Federal, State, and local
fire prevention regulations. Check with appropriate au-
thorities. Contact customer service or a qualified service
center to purchase a replacement spark arrestor.

Inspect the spark arrestor for breaks or holes. Replace if
necessary.

Use a brush to remove carbon deposits from the spark
arrestor screen as needed.
DRAINING FUEL TANK/CARBURETOR
See Figures 20 - 22.
To help prevent gum deposits in the fuel system, drain the
fuel from the tank and carburetor before storing.
DRAINING THE FUEL TANK

Turn the engine switch OFF ( O ).
 Turn the fuel valve to the
OFF (O )
position.

If necessary, push the fuel valve knob through the genera-
tor housing and pull down slightly to gain access to the
petcock.
  Remove the fuel line from the petcock by squeezing the
ends of the retaining clip and sliding the fuel line off.

Install one end of a drain line over the petcock, and place
the other end in a fuel container large enough to catch
the fuel being drained from the tank.
 Turn the fuel valve to the
ON ( l )
position.

When the fuel has drained from the tank, close the fuel
valve and reinstall fuel line securely on petcock.
 If previously removed, reinstall fuel valve knob in genera-
tor housing. Push forward until knob snaps securely into
position.
DRAINING THE CARBURETOR
 Turn the engine switch
OFF ( O )
.

Turn the fuel valve to the OFF ( O ) position.
 Position a suitable container under the carburetor drain
screw to catch fuel; loosen the screw.

Allow fuel to drain completely into container.
 Retighten drain screw.
NOTE : Consult hazardous waste management guidelines in
your area for the proper way to dispose of used fuel.
REPLACING FUEL FILTER
See Figure 21.
Occasionally the fuel filter may become clogged and need
to be replaced. To purchase a replacement fuel filter contact
customer service or a qualified service center.
NOTE: Fuel tank must be empty before replacing fuel filter.
Run unit until tank is empty, if needed, or inspect filter prior
to fill-up.
To replace:

Turn the fuel valve to the OFF ( O ) position.


Remove the fuel line from both sides of the filter by
squeezing the ends of the retaining clip with pliers.


Slide the fuel line off.


Replace with new fuel filter.
  Reinstall fuel lines to new fuel filter.
  Pull on lines to make sure they are secured
 Turn the fuel valve to the
ON ( I )
position.
CHANGING ENGINE BATTERY CHARGE
CIRCUIT FUSE
See Figure 23.
NOTICE:
Do not use a higher rated fuse other than the specified
amperage. This could cause damage to the product.

Open the cover and pull out the fuse.

Insert the new fuse.

Close the cover.
TRANSPORTING

Turn the engine switch OFF (O). Disconnect any equip-
ment that is plugged into the generator.
 Turn the fuel valve to the
OFF ( O )
position.

Allow 30 minutes of “cool down” time before storing the
machine. Make sure engine and exhaust of unit are cool.
 For security, insert the pins to secure the handle before
transporting.

Tilt the machine toward you slightly until it balances on
the wheels then roll the machine to the desired position.
Do not tilt forward or sideways when moving.
 If transporting in a vehicle, drain the fuel tank, close the
fuel valve and securely restrain the generator.

Provide a plastic sheet or absorbant pad below the gen-
erator to catch any drips of fuel or lubricant.
MAINTENANCE