Power Products TENERIFE, Инструкция по эксплуатации

Страница: 55 / 106

E
sp
a
ñ
o
l
53
E
n
g
lis
h
P
o
rt
u
g
u
ê
s
E
sp
a
ñ
o
l
E
n
g
lis
h
P
o
rt
u
g
u
ê
s
NOTE: Do not connect welding machines. The continuous alternations of
intensity of the welding current does a continuous stress in the inverter module,
which can be damage.
NOTE: Never start the generator with equipment connected. Disconnect all
equipment before starting the engine.
WARNING: before connecting to the generator, confirm if all equipment is in
good working conditions.
If an equipment runs abnormally, slowly or spontaneously shuts down, stop the
generator immediately and disconnect the equipment.
To improve engine performance and to give more life to the generator, a running-
in (without forcing the engine) period of 20 hours is recommended, with a power
consumption up to 60% of the maximum power produced by the generator.
8.2 ECO mode
ECO mode is used to reduce fuel consumption and noise level, especially when
the power consumption for the connected equipment is low.
When the mode is activated - ON position of the switch - the engine rotation
remains low. Gradually the rotation increases according to the power consumption
of the connected equipment. ECO mode is recommended for power consumptions
between 0 and 3500W.
If you switch off the ECO mode - OFF position of the switch - the rotation
increases to its nominal speed, which provides greater capacity for higher power
consumptions.
NOTE: If you connect equipment with a high power consumption, no activate
ECO mode. Especially, in case of inductive equipment with starting peak current.
NOTE: If you connect equipment with a constant variation (low and high) of
the power consumption, do not activate ECO mode.