Power Fist 9007824, Руководство пользователя

Страница: 12 / 32

Problem(s) Possible Cause(s) Suggested Solution(s)
Tool runs at normal
speed, but loses
power under load. 1. Motor parts worn. 1. Have a qualified technician service
the tool.
2. Replace tool or parts.
Tool runs slowly.
Air flows slightly
from exhaust.
And/Or
Air flows slightly
from nozzle. 1. Motor parts jammed
with dirt particles.
OR
Airflow blocked by
dirt.
2. Air regulator in closed
position.
3. Damage or excessive
wearing of internal
parts.
1. Check air inlet filter for blockage.
a.
Pour air tool lubricating oil into
air inlet as per lubrication
instructions for clearing
shipping grease.
b. Operate tool in short bursts to
clear debris.
c. If tool still jammed, clean tool
and lubricate per lubrication
instructions.
2. Open the air regulator to desired
airflow.
3. Have a qualified technician service
the tool.
a.
Replace tool or parts.
Tools will not run.
Air flows freely
from exhaust. 1. Damage or excessive
wearing of internal
parts. 1. Have a qualified technician service
the tool.
2. Replace tool or parts.
Tool will not shut
off. 1. Throttle valve o-ring
dislodged from inlet
valve seat.
2. Trigger mechanism
jammed or dirty.
1. Replace throttle valve o-rings.
2. Clean trigger mechanism and
lubricate.
Loss of power or
erratic
performance. 1. Excessive drain on the
air hose. Incorrect size
or type of hose
connectors.
2. Moisture or restriction
in the air hose/tank
3. Air compressor has
insufficient flow.
1. Check the air hose and confirm the
hose fitting is correct for the inlet
bushing.
2. Depressurize system and drain tank
and air hose of water.
3. Ensure tool is connected to a
compressor with a rate flow that
matches the tool.
9007824 PISTOL-GRIP AIR SCREWDRIVER V1.0
www.princessauto.com / 1-800-665-8685 Page 12