Power Fist 8843583, Инструкция по эксплуатации

Страница: 11 / 32

V1.0 Long Barrel Air Hammer 8843583
Visit www.princessauto.com for more information 11
8. Once finished, disconnect the tool from its air source and discharge
any residual air in the tool before storing it.
9. Remove the chisel and the spring retainer after each use. Clean the air
hammer, retainer and chisels to make sure there is no accumulated
dust or debris remaining on the tool. Reinstall the retainer back onto
the air hammer before storage.
CARE & MAINTENANCE
1. Maintain the tool with care. A tool in good condition is efficient, easier
to control and will have fewer problems.
2. Inspect the tool fittings, alignment, hoses and power supply cord
periodically. Have damaged or worn components repaired or replaced
by an authorized technician. Only use identical replacement parts
when servicing.
3. Follow instructions for lubricating and changing accessories.
4. Only use accessories intended for use with this tool.
5. Keep the tool handles clean, dry and free from oil/grease at all times.
6. Maintain the tool’s labels and name plates. These carry important
information. If unreadable or missing, contact Princess Auto Ltd. for
replacements.
WARNING! Only qualified service personnel should repair the tool. An
improperly repaired tool may present a hazard to the user and/or others.
AIR TOOL LUBRICATION
NOTICE! Only use air tool oil to lubricate the tool. Other lubricants are not
suitable and will damage the tool or cause a malfunction during use.
NOTICE! Never use a penetrating oil to lubricate an air tool. Penetrating oil
acts as a solvent that will dissolve the tool’s grease packing and may
damage the o-rings, causing the tool to seize or malfunction.
1. All air tools have an internal coating of grease to prevent corrosion
during shipping and storage. Remove this grease by adding a generous
amount of air tool oil in the air inlet and then run the tool under no
load until the exhaust is clear.
2. Manually add a drop or two of air tool oil into the tool’s male coupler
before each use and after every hour of continuous use. The tool will not
work properly without lubrication and parts will wear prematurely.