Power Fist 8843583, Инструкция по эксплуатации

Страница: 10 / 32

8843583 Long Barrel Air Hammer V1.0
10 For technical questions call 1-800-665-8685
3. Remove by unscrewing the spring retainer (A) using the inner lug.
4. Select your chisel (F to J). Make sure it is in good working condition and
will not shatter or break while in use.
5. Push the chisel into the air hammer until seated.
6. Slide the retainer spring over the chisel, then screw it onto the
cylinder’s (B) threads until seated. Twist the coil by the front lug. It will
spread the coils out slightly, making it easier to thread.
7. Pull on the chisel to confirm it is locked into place.
8. Test the chisel placement by running the tool at no load for approximately
30 seconds. Point the chisel in a safe direction in case it is ejected from the
air hammer.
OPERATION
PRESSURE DROP
Apply the air consumption and pressure rate numbers to the tool’s air inlet, not
the compressor’s outlet. Calculate the pressure drop for your air supply set-up
and increase the compressor outlet pressure to compensate. Make sure you do
not exceed the maximum pressure for any part of your air supply system.
Installing a pressure gauge at the tool inlet is the best way to measure the
air pressure and adjust the compressor’s output.
TOOL OPERATION
1. Ensure the regulator switch is in the neutral or OFF position.
2. Connect the tool to the air source.
3.
Turn the compressor regulator to the desired air pressure (see
Specifications).
4. Power is increased or decreased by adjusting the air flow with the
regulator (E) at the handle’s base.
5. Firmly grip the air hammer with both hands and place the chisel
against the workpiece.
6. Squeeze the trigger (C) and slowly move along the workpiece. Do not
force the air hammer; let the tool do the work.
7. If the chisel is not performing well, turn off the tool and examine the
chisel to see if it is dull. Replace with a sharp chisel. Remember that
sharp tools are safer than ones that have become dull.