Power Fist 8843583, Инструкция по эксплуатации

Страница: 9 / 32

V1.0 Long Barrel Air Hammer 8843583
Visit www.princessauto.com for more information 9
IDENTIFICATION KEY
A Retainer Spring
B Cylinder
C Trigger
D Air Inlet
E Air Regulator
F Chisel, Ripper
G Chisel, Bushing Cutter
H Chisel, Tapered Punch
I Chisel, Flat Punch
J Chisel, Weld Buster/Bolt Cutter
ASSEMBLY & INSTALLATION
Letter references in parenthesis (A) refer to the included Identification Key.
INSTALL AIR BODY PLUG
Prepare a standard 1/4 in. NPT male air body plug (sold separately) for use
with your tool.
1.
Wrap the external threads of the air body plug with sealant tape.
a.
Wrap tape in a clockwise direction so it will not unravel.
b. Do not tape all the threads. Leave several leading threads
unwrapped for easier alignment.
2. Screw the air body plug into the tool's air inlet (D) and tighten with a
wrench until snug.
3. Run the compressor at a low volume and check the connection for air
leaks. Do not use the tool until all air leaks are repaired or the faulty
component is replaced.
IMPORTANT! Vibration may cause failure if a quick coupler is connected directly
to the air tool. To overcome this, connect a leader hose to the tool. A quick
coupler may then be used to connect the leader hose to the air line hose.
INSTALL THE SPRING RETAINER AND CHISEL
1. Remove the internal packing grease from the tool before the first use.
See Air Tool Lubrication for instructions.
2. Disconnect the tool from its air source and discharge any residual air before
attaching or changing chisels or accessories.
Fig. 1