3/8 in. dr Composite Air Ratchet
11
Visit www.princessauto.com for more information
8344103
V 2.0
3. Once a month, lubricate the drive bushing and the ratchet yoke with a high quality bearing
grease.
4. Periodically remove, clean and re-grease the ratchet head assembly. How often this should be
done depends on the frequency of use.
STORAGE
When not in use for an extended period, apply a thin coat of lubricant to the steel parts to avoid rust.
Remove the lubricant before using the tool again.
DISPOSING OF TOOL
If your tool has become damaged beyond repair, do not throw it out. Bring it to the appropriate recycling
facility.
TROUBLE SHOOTING
If the tool does not function properly or if it is missing parts, contact Princess Auto Ltd. for a solution. If
unable to do so, have a qualified technician service the tool.
Problem(s)
Possible cause(s)
Suggested solution(s)
Tool runs at normal speed but
loses power under load.
Motor parts worn
Have a qualified technician
replace worn parts.
Lack of air tool oil.
Pour air tool oil into air inlet per
instructions.
Tool runs slowly. Air flows
slightly from exhaust.
Motor parts jammed with dirt
particles.
1. Check air inlet filter for
blockage.
2. Pour air tool oil into air inlet
as per instructions.
3. Operate tool in short bursts
quickly reversing rotation
back and forth where
applicable.
4. Disconnect air supply. Free
motor by rotating drive
shank manually where
applicable.
5. Repeat above as needed. If
this fails, bring to service
centre.
