Power Fist 8095903, Руководство пользователя

Страница: 6 / 11

Fittings: Install a male plug on the tool
which is free flowing and which
will release air pressure from the
tool when disconnected from the
supply hose.
Hoses: Hose with a 1/4" I.D. should have
a max length of 15 ft. For lengths
over 15 ft, use 3/8" I.D. hose. The
supply hose should contain a
fitting that will provide quick
disconnecting from the male plug
on the tool.
Supply source: Use only clean regulated compressed air as a power
source for the tool.
Filter, regulator, lubricator (F.R.L.): (Inline air filter, regulator, oiler)
Refer to tool specifications for
setting the correct operating
pressure for the tool.
Note: a filter will help to get the best performance and minimum wear
from the tool because dirt and water in the air supply are major
causes of wear in the tool. Frequent, but not excessive, lubrication
is required for the best performance. Oil added through the air line
connection will lubricate the internal parts.
Operating Instructions
Eye protection is required to guard against flying fasteners and debris,
which could cause severe eye injury. The user must ensure that proper eye
protection is worn., Eye protection equipment must conform to national
safety standards and provide both frontal and side impact protection.
NOTE: non-side shield spectacles and face shield alone do not provide
adequate protection.
Warning: always disconnect the air supply from the tool when operation
has been completed or suspended, when moving to a different
work area, adjusting, disassembling, or repairing the tool, and
when clearing a jammed fastener.
F.R.L.
8095903manual 11/4/05 3:06 PM Page 6