DB SERIES
POWER ELECTRONICS
4.2.
Leds Description
4.2.1.
Dynamic Braking Unit – GROUP 1
4.2.2.
Dynamic Braking Unit – GROUP 2
LED
DESCRIPTION
When the heat sink is overheated and the
level exceeds its set limit, overheat
protection is activated and this led is turned
on after the signal is shut off.
OHT
(Red)
It is turned on when the braking unit receives
power supply, because usually it is
connected to the drive.
POWER
(Red)
It is blinking while dynamic braking unit is
operating correctly due to the energy
regenerated by the motor.
RUN
(Green)
Figure 4.3 Leds for DB Unit - G1
LED
DESCRIPTION
Press this switch to release OCT fault
(overcurrent). Pressing this switch the OCT
led is turned off.
RESET
It is turned on when the braking unit receives
power supply because usually it is
connected to the drive.
POWER
(Green)
It is blinking while dynamic braking unit is
operating correctly due to the energy
regenerated by the motor.
RUN
(Green)
When the heat sink is overheated and the
level exceeds its set limit, overheat
protection is activated and this led is turned
on after the signal is shut off.
OHT
(Red)
Overcurrent trip signal. When an over
current occurs in the IGBT, this protection
function turns off the operation signal and
the OCT led is turned on.
OCT
Figure 4.4 Leds for DB Unit – G2
(Red)
20
INSTALLATION OF DYNAMIC BRAKING UNIT
Содержание SDRIVE DB Series
