Potterton Suprima 100L, Инструкция по установке и обслуживанию

Страница: 82 / 100

Supplied By www.heating spares.co Tel. 0161 620 6677
Publication No. 5102871 2 User's Guide
Boiler
Code
Number
Bar
Code
Model
GC. No.
Data
Badge
Controls
Cover
SUP0281A
Reset
Button
L.E.D.
(Green)
L.E.D.
(Red)
Temperature
Control
('0' Standby)
Optional
Programmer
Temperature
Reset
M a x 0
POTTERTON
G.C. No. 41 590 42
9016
BOILER CODE No. ALVG101 0003
SUPRIMA 30 L
To Light
Note: When the boiler is first operated, there may be a slight
smell. This will disappear with use.
1. Ensure that the boiler thermostat knob is set at 'O' (fully
anti-clockwise).
2. Switch ON the main electricity supply, the upper Red
L.E.D. should be on.
3. Ensure the electronic programmer or other time control,
if fitted, is in an 'ON' position (refer to the time control
literature).
4. Ensure that any room and/or cylinder thermostats are at
a high temperature setting.
5. Turn the boiler thermostat 'ON' and to the required setting
and the lower Green L.E.D. will start to flash. After a short
period, the lower Green L.E.D. will flash rapidly and then
become constant as the boiler lights up. When the boiler
reaches the temperature setting on the boiler thermostat,
the boiler will switch off, the Red L.E.D. will come on and
the Green L.E.D. will flash.
6. Set the time control and any thermostats to their desired
settings.
Reset Button
If the boiler fails to light after three attempts it will lockout and
the Red L.E.D. will start to flash. Press the reset button (
Do
Not use excessive pressure), the Red L.E.D. will stop flashing
and the boiler will attempt to relight a further three times.
If the boiler will not light, then you should call your installer
or maintenance contractor.
To Shut Off - Short Periods
Turn the boiler thermostat knob to 'O' (Standby) or switch the
programmer to the 'OFF' position. To operate the boiler,
simply turn the boiler thermostat to the required setting and
switch the programmer 'ON'.
To Shut Off - Long Periods
Turn the boiler thermostat knob to 'O' (Standby), isolate the
electrical supply at the isolating switch, or pull the electrical
plug out of the wall socket.
Important: Read the section on Frost Precaution.
Temperature Control
This enables you to control the temperature of the water as
it leaves the boiler and is also used for turning the boiler on
and off. The control can be set between 'O' (Standby) and
Max which corresponds approximately to a temperature
range of 55 °C to 82 °C
During the summer months, when the boiler is only being
used to supply stored domestic hot water and there is no
independent hot water temperature control, the thermostat
can be set to a low setting which will probably be hot enough
for bathing or washing up requirements. For washing clothes
a higher setting may be necessary.
In winter weather, when central heating is required, the
thermostat knob can be turned up higher but it must be
remembered that unless the temperature of the water in the
domestic hot water cylinder is independently controlled, the
stored hot water could be at a temperature that could scald.
SEDBUK Declaration for Suprima
Model Seasonal Efficiency
(SEDBUK) (%)
30L 78.0
40L 78.5
50L 78.1
60L 78.1
70L 78.7
80L 78.8
100L 78.0
120L 78.7
This value is used in the UK
Government's Standard Assessment
Procedure (SAP) for energy rating of
dwellings. The test data from which it
has been calculated have been certified
by 0063.
Warning
Do not interfere with any sealed components
on this appliance
It is important that the case of this appliance is not
removed for any reason other than for servicing
by a qualified service engineer.
The appliance must not be operated without the
casing correctly fitted and forming an adequate seal.
Avoid skin contact when the boiler is in operation, as
some surfaces may get hot i.e. sight glass, pipework.