Potterton Suprima 100L, Инструкция по установке и обслуживанию

Страница: 21 / 100

Supplied By www.heating spares.co Tel. 0161 620 6677
Publication No. 5102696
21
13. If the boiler fails to operate
Check the LED indicator fault modes below and refer to
fault finding guide and boiler wiring diagram.
LED Indicators Fault Modes
Status Green LED Red LED
Blocking - Mains Frequency ON FLASHING
incorrect or Air Switch Fault 2 Per Sec.
> 1 min. or Reset button held
in to force a restart
Earth Fault or FLASHING FLASHING
Mains Reversal 2 Per Sec. 2 Per Sec.
Lockout OFF FLASHING
2 Per Sec.
3.2 Final Adjustments
1. Use a pressure gauge to check the inlet and burner
pressures. See the Data Badge for figures.
2. Turn the boiler on and allow to run for 10 minutes.
3. Check that the inlet pressure is 20mbar.
4. Check that the burner pressure is in accordance
with the information on the boiler data badge. The
gas valve is factory set, but if adjustment is required
follow Section 4.3.7 or 4.3.10.
5. Check at the gas meter that the gas rate is correct.
6. Set the temperature control knob to 'O' Standby and
check that the main burner shuts down. Remove the
pressure gauges, re- fit the screws and check for gas
soundness.
7. Re-fit the controls cover and secure with the screw
previously removed.
Control Thermostat
At its minimum and maximum settings, the thermostat
should control the water flow temperature at
approximately 57 °C - 82 °C.
Overheat Thermostat
The overheat thermostat is pre-set and no adjustment
is possible. It will require manual re-setting if an
overheat condition occurs (the LED will go to flashing
Red).
The re-set button is located on the controls assembly.
Commissioning
Other Boiler Controls
No further setting or checking is necessary as all
boiler mounted controls are designed so that if a
fault should occur they will fail safe.
External Controls
Check that any other external controls connected in
the system, such as clocks or thermostats, control
the boiler are set as required.
3.3
Advise the User
On completion of the installation, the installer should
demonstrate the operation of the boiler and its associated
controls. Also hand over all the instructions.
1. If a programmer is fitted, set the time and programme
the required settings as shown in the instructions
supplied with the programmer.
2. Advise the user of the precautions necessary to
prevent damage to the system and to the building in
the event of the system remaining inoperative during
frost conditions.
3. Advise the User that for continued efficient and safe
operation of the boiler it is important that adequate
servicing is carried out at least once a year by a
Potterton Service Engineer, the local Gas Supplier
or a C.O.R.G.I. Registered Installer.
4. Leave a permanent card attached to the boiler
giving:
a. Name and address of installer.
b. Date of installation.
c. A wiring diagram of the external control circuit.
5. And finally, complete the Benchmark Log Book and
hand over all the instructions supplied.