Potterton Suprima 100L, Инструкция по установке и обслуживанию

Страница: 12 / 100

Supplied By www.heating spares.co Tel. 0161 620 6677
Publication No. 5102696 12 Installation Requirements/Installation
Circulation Pump Selection
The resistance through the heat exchanger
when operating with a water flow rate producing
an 11°C temperature rise at maximum boiler
output are shown in the table. If other controls
such as three position valves are used in the
system, the resistance through them, quoted in
their manufacturers literature must be taken
into account. The pump may be fitted on either
the flow or return and MUST be wired directly to
the boiler terminal block. It must be fitted with
two isolating valves which are positioned as
close to the pump as possible. Closing of any
valve must always leave the open vent
unobstructed.
Water Flow Rate Boiler Resistance
l/min
11.5
15.2
19.2
22.9
26.7
30.5
37.4
mbar
17.5
35.3
44.9
59.5
80.9
105.3
147.0
m
0.18
0.36
0.46
0.61
0.83
1.08
1.50
30
40
50
60
70
80
100
2. Installation
2.1 Unpack & Prepare the Boiler
These instructions assume you have decided on where the boiler will be located and the type of flue system to be used.
1. Carefully unpack the boiler.
2. Do not discard any packaging until all the items are accounted for.
3. Open the controls cover, remove the securing screw and washer, pull off the controls cover and put safely aside.
4. Remove two screws and washers, remove the white front case and put safely aside.
5. Place the mounting template in the proposed boiler position ensuring that it is level. Minimum clearances are accounted
for on the template.
6. Mark the flue hole, remove the template and carefully cut the flue hole through the wall.