The default IP address of the card is 192.168.1.2 – the Ethernet interface on the bracket is auto speed detect and auto cable cross over.
For configuration you may connect directly to the Ethernet interface or through a switch. No special cable is required.
Drivers
Windows XP/2000 and Linux source code are available on the CD along with installation instructions.
IMPORTANT:
If you want to connect to the PCI card from the Host PC, you need to ensure the IP address is configured on the same
segment as the PCI card. For example, if the default IP address of the card is 192.168.1.2, then a suggested IP address for the Host PC driver
is 192.168.1.10.
LED Functionality
The LED on the PCI bracket provides state / diagnostic information. The table below describes each state:
Factory Reset
In the event that a configuration does not allow connectivity to the system, a user may perform a factory reset that will put all the IP
addresses and passwords back to the default settings. Instructions: Push and hold the reset button for approximately 20 seconds.
Positron Telecom • 5101 Buchan Street, Suite 200, Montreal, Quebec, Canada H4P 2R9 • Tel: (514)-345-2220 • Email: [email protected] • www.positrontelecom.com
Document Code:
44-00029-03
Event
LED
NOTE:
When you push and hold the reset button, the LED light will be
GREEN solid. When factory reset is complete, the GREEN and RED will be
solid and the button can then be released.
Reset Button
Card is booting
GREEN to RED blinking
Operating system loading
Only GREEN blinking
System fully loaded and operational
GREEN solid
Hardware failure
RED solid
Ethernet (optional - requires driver)
To PCI Bus
Ethernet
192.168.1.2 (static)
Think Inside the Box
