Page 9
Step C:
Pull up the printer cover.
Step D:
Loading the paper roll and please notice that the paper roll’s
orientation should be face the printer head.
Step E:
Please pull the paper longer then paper exit and close the printer cover
at the centre of front and please watch your finger during this step in
order to reduce hurt occur.
After finished steps A to E, the printer will cut the excess paper automatically
after the paper cover closed if the system power is turn on.
Note 1:
In order to protect the users’ fingers,
please notice that the push lock button in the
lock/release lever. When the LCD panel needs to be
push or pull from the most rear end, please press
the push lock and the lock/release lever at same
time then the LCD panel can pull or pull from the
rear end . Otherwise, the final level of tilt angel will be lock. The push lock
button only work when push or pull the final level of the LCD panel
adjustment.
Paper Near End Sensor
The near end sensor for
paper roll in the printer
is able to have the printer
work with paper rolls of
several
bobbin
sizes.
Please
refer
to
the
picture at right for the
inside of the paper roll
compartment that there
are a plastic thumb
wheel for bobbin size
B
C
C
D
E
Sensor Position
Adjust
Support Roller
Sensor Block
