Part 7
Use the normal USB Cable (P/N: 21863250800) as in the left picture to
connect the type A end to a normal USB port of POS system. Please visit our
web site
http://www.posiflex.com
or
http://www.posiflex.com.tw
for detailed
information of the USB driver installation if required. Please note that for PP-
6900U, there must be no cable connection at either the serial port or the
parallel port on the printer. Set in setup window the
switch position 1 to OFF,
and position 2 to ON leaving the rest unchanged as factory default setting.
Serial Connection
All the external connectors are in the recessed area at the rear
bottom for PP-
6900 series. The serial connector is a 9-PIN D sub Female connector. Apply
the male connector of RS232 cable to this port for serial application. Please
note that when serial connection is used, there must be no cable connection at
the USB port on the printer. The default protocol used in serial connection is
115,200 bps, none parity, 8 data bits, 1 stop bit. Set in setup window the
switch position 1 to OFF, and position 2 to ON leaving the rest unchanged
as factory default setting.
Virtual Serial Port
A virtual serial port is a redirector driver used in USB interface which is
usually used to create a pair of back-to-back virtual COM ports on the same
computer. It can then communicate using virtual serial ports instead of
conventional inter-process communication mechanisms.
Parallel Connection
The parallel connector is a 25-PIN D sub Male connector. Apply the female
end of the parallel cable at this port for parallel application. Please note that
when parallel connection is used, there must be no cable connection at the
USB port on the printer. Please also note to keep parallel interface in fast
operation, please adjust in setup window the
switch position 1 to OFF, and
position 2 to ON leaving the rest unchanged as factory default setting
.
LAN Connection
The LAN connector is a 8-PIN RJ45 type modular connector. Please use a
LAN cable of CAT 5 with proper length to connect the LAN connector on the
printer to the LAN HUB as appropriate. Please note that for PP-6900L, there
must be no cable connection at the USB port on the printer. Please also note
that to keep LAN interface operative, please adjust in setup window the
switch
position 1 to OFF, and position 2 to ON leaving the rest unchanged as
factory default setting. Do not connect the peripheral device (cash drawer)
to this port!!
The LAN port is 10/100baset compliant.
