Part 13
as described in previous section. Also print density is regulated thru switch
settings.
Paper Jam Problems
Paper is jammed inside the printer
– Push down the paper cover release
button then the top paper cover can be released. Remove the jammed paper
and reinstall the paper roll. Close the paper cover properly and firmly for
operation.
If the auto cutter is also jammed, the top hood will be locked. However, in
most of the situations the cutter will retract automatically when the hood
release button is released, please re-close the hood and try opening it again.
Never force open the top hood.
Please also clear away any containments
accumulated in the cutter track above the thermal elements.
Advanced Analysis Tool
This printer supports
Hexadecimal Dump
for experienced user to
view exactly what data is received by the printer. This can be useful in finding
software problems.
To start the dump mode: Turn off printer; Open print hood; Hold
down FEED button while turning printer on; Close the hood.
To stop the dump mode: Press the FEED button to print out the last
line; Turn off the printer.
During dump mode: All commands except
DLE EOT
and
DLE ENQ
are disabled.
USEFUL TIPS
•
Please note that only those qualified technicians may adjust several
jumpers for some technical settings. Please visit our web site
http://www.posiflex.com
or
http://www.posiflex.com.tw
for details of the
technical information such as driver installation, DIP switch settings and
command sets etc. if required.
•
Place the printer on a sturdy, level surface.
•
Choose a place that is well ventilated and free of excessive dust, smoke or
fume.
•
Do not put the printer under direct sunlight or near a heater.
•
Ideal room temperature is from 5ºC to 40ºC. Ideal humidity is from 20% to
85% RH (no condensation).
•
Do not set any liquid or drinks such as coffee on the printer case.
•
Do not touch any metal part to avoid possible electrostatic damage.
