POSIFLEX KS-6115, Руководство пользователя

Страница: 10 / 20

Part 10
outside of the bottom plate from inside as circled in the right picture that is the
bottom view of the base stand. Then use the 4 larger screws to fix the monitor
support rod from bottom as arrowed in the same picture. Route the VGA
through the cable exit of the base stand to the main unit. Connect the attached
power adaptor for its power source.
ROUTING THE CABLES
Place all the cables required for connections to the
main unit through the front part inside the stand assembly.
Be sure not to damage any cable during this operation.
Now, turn the adjustable stand assembly back to
normal orientation and
arrange all cables to
come out of the area for
mounting main unit from the lower front edge for ease of
later operation.
PREPARING THE MAIN UNIT
On the back of the main unit, there is a service window among the 4
matching pegs. Remove the service window lock screw to find several jumpers.
The jumpers in this window are designated for VGA port and COM port power
supply function. Please consult your dealer for technical support on setup of
these jumpers. Please note that only those qualified technicians may adjust in
the service window with information from Posiflex
and the contents in the service window may change
without notice as time develops.
SIDE MOUNT UPGRADE KIT
Remove the 2 circled screws in right picture above to
remove the cover for side mount upgrade kit. Take out the
cable inside this cover as circled in right picture and remove
the 2 shorting jumpers inside if exist and then connect it to
connector inside the side mount upgrade kit like SD400 as
arrowed in left part of the same picture. Gently arrange the
excessive length of this cable back in the hole and screw-fit it
back to the position originally occupied by the cover. Please reserve the cover
if there is chance to have the side mount kit removed in the future.
Route Cables through Front Part
Connect this End to Main Unit
Service Window
Lock Screw
Jumpers