System Installation
NANO-8045 User’s Manual
3-2
3.3 Main Memory
NANO-8045 provides one 200-pin DDR2 SO-DIMM socket which supports 400/533
DDR2-DRAM as main memory, Non-ECC (Error Checking and Correcting),
non-register functions. The maximum memory size can be up to 1GB capacity.
For system compatibility and stability, do not use memory module without brand.
Memory configuration can be either one double-sided DIMM in either one DIMM
socket or one single-sided SO-DIMM in socket.
Watch out the contact and lock integrity of memory module with socket, it will
impact on the system reliability. Follow normal procedures to install memory module
into memory socket. Before locking, make sure that all modules have been fully
inserted into the card slots.
Note:
To maintain system stability, don’t change any of DRAM parameters in BIOS setup to
upgrade system performance without acquiring technical information.
Memory frequency / CPU FSB synchronization
NANO-8045 supports different memory frequencies depending on the CPU front
side bus and the type of DDR2 SO-DIMM.
CPU FSB
Memory Frequency
533MHz 533/400MHz
400 MHz
400MHz
3.4
Installing the Single Board Computer
To install your NANO-8045 into standard chassis or proprietary environment, please
perform the following:
Step 1 : Check all jumpers setting on proper position
Step 2 : Install and configure memory module on right position
Step 3 : Place NANO-8045 into the dedicated position in the system
Step 4 : Attach cables to existing peripheral devices and secure it
WARNING
Please ensure that SBC is properly inserted and fixed by mechanism.
Note:
Please refer to section 3.4.1 to 3.4.4 to install INF/VGA/LAN/Audio drivers.
