4. Switching the remote control between the switch and pushbutton
mode
The remote control can be operated in two modes:
Switch mode
By pressing and releasing the UP or DOWN button, the previously programmed
function of a motor will be activated (opening or closing the roller shutter). The motor will
work only when the button is being pressed. Releasing the key will stop the motor. After
pressing the button for longer than 2 seconds the motor will enter the switch mode, that
is, it will work until the roller shutter is completely closed or opened.
Pushbutton mode
By pressing and releasing the UP or DOWN button, the previously programmed
function of a motor will be activated (opening or closing the roller shutter). The motor will
work only when the button is being pressed. Releasing the key will stop the motor. After
pressing the button for longer than 2 seconds the motor will enter the switch mode, that
is, it will work until the roller shutter is completely closed or opened.
Switching between particular modes can be performed in the following way:
Choose the channel which has been previously programmed.
1.Press the P2 button once, the motor will emit a single sound.
2.Press the UP button, the motor will emit a single sound.
3.Press the P2 button again, it will be signaled by 3 sounds emitted by the motor
The shift of the mode on the remote control has been completed. This change relates to
all channels and remote controls that are going to be assigned to the motor.
Operating
The remote control’s range as well as the quality of radio signal can be influenced by
local interferences such as motors or other radio devices operating in the same
frequency. If there is no reaction of the motor when using the remote control, you should
send a command again after moving the remote control to another area of the room.
Device must be kept clean and protected from dirt. The device should not be exposed to
extreme temperature, moisture or vibrations. To change the battery you should take out
the device from the frame. The battery is located at the back of the device. While
changing the battery you should not use any metal tools. Only batteries CR2430 can be
used. After replacing the battery with the new one, the device is ready to work. The
controlling device should be protected from access of undesirable persons. Before
throwing away the device, remember to delete all motors assigned to it. The device that
is no longer needed, should be disposed of in accordance with the rules and regulations
of the country you inhabit.
CAUTION
– PROCEEDINGS ACCORDING THIS MANUAL IS IMPORTANT FOR
THE SAFETY OF PEOPLE.
P2
MODE
TIME
P2
MODE
TIME
!!!
4
