The programming on the channel
Switch the electricity ON. The motor will make a short beep and will vibrate ( short
movement up & down ). The motor is in programming mode for 12 seconds. If no button
will be pushed within these 12 seconds the motor leaves the programming procedure.
Choose the channel that You wish to program ( for remotes with more than one
channel ).
1.Press the P2 button, the motor will emit a single sound.
2.Press again P2 button. The motor will emit a single sound again.
3.Press either button Up or DOWN. The programming will be confirmed by 6 short
beeps and after that the motor will vibrate, meaning that the programming was
successful.
After the programming procedure is finished You need to verify the directions on the
remote by simply starting the motor. If the directions are swapped then the
programming procedure needs to be done once more, eg:
If the motor has been programmed using the procedure two times P2 and then DOWN
button and the directions are swapped, then we need to program the motor again using
the opposite procedure, meaning two times P2 and then UP button.
ON
P2
MODE
TIME
P2
MODE
TIME
ON
P2
MODE
TIME
P2
MODE
TIME
!!!
CAUTION!!
When programming, only the tubular motor which is to be programmed needs
to be power supplied.
2
