In Commercial Confidence
12
1) Input trigger report
All input trigger reports are also configurable. User can customize the events generated by the in-vehicle input to be sent
to the server. To enable the particular trigger reports by click the box.
2) Sleep mode (when Duty-Off)
(1) TLU100N can go to sleep mode when duty off and TL-sensor is not trigged for 5 minutes. In sleep mode, GPS &
GPRS will be disabled.
(2) During the sleep mode, the system can wake up automatically to check if anything need to be processed and will
send a wake up diagnostic report.
(3) During the sleep mode, if any of the inputs are triggered, the system will wake up automatic report and then send
reports to the server.
X.
WIRELESS SENSOR ID LEARNING:
In order to match a wireless sensor to host, the TLU100N host must memorize its related wireless sensor’s ID by this both
of the device created a valid communication measure, which is called ID learning. In TLU100N system there are two
sensor need code learning before putting to use, they are wireless door sensor and wireless temperature sensor. Both of the
two devices will send their ID to host every 30 seconds at the beginning 3 minutes after powered on. If the host’s sensor
ID learning function was enabled then host will get a new sensor ID and save it to its nonvolatile memory. There are two
ways by which user can enable TLU100N host’s wireless sensor ID code learning function.
1.
On board jumper code learning
¾
Put the on board ‘JP1’ jumper to “ON” to let host enter wireless sensor ID accepting state. The ID learning
indication LED of host will light on.
¾
Power on the wireless accessory soon, the sensor will send out its ID into air and at the same time the LED of the
sensor will flash.
¾
The ID learning indication LED of host will flash 3 times for every successful sensor ID learning.
¾
Power on next device that need to be learned until all of them are finished.
¾
Put back the on board ‘JP1’ jumper to “OFF” as soon as all sensor be learned successfully, the host will exit the
code learning state.
Note that:
1)
Both temperature and door sensor can achieve ID learning by this same way.
2)
Nothing will be changed if no any sensor ever sent ID learning request to the host during ID learn valid
period.
3)
All previous ID will be cleared as soon as a same kind sensor ID learning request arrived first time, the new
ID will then be saved.
4)
Do not forget to put back ‘JP1’ to “OFF” state after code learning over, or else new ID learning request may
destroy the original ID.
2.
Keypad command code learning
Wireless temperature and door sensor have different keypad commands for ID learning, e.g.:*88*# for door sensor
and *
99*
# for temperature sensor.
A: wireless temperature sensor ID learning
¾
Input “*
99*
#” to enable temperature sensor ID learning.
¾
Power on the wireless accessory soon, the sensor will send out its ID into air and at the same time the LED of
the sensor will flash.
¾
The buzzer on keypad will beep for successful sensor ID learning.
¾
Input “*
90*
#” to disable temperature sensor ID learning, the buzzer will beep to indicate a successful
operation.
