Porter CENTER-STRUT, Инструкции по сборке, установке и обслуживанию

Страница: 14 / 17

14
WIRING REQUIREMENTS – SPORTSONIC
“
II OPERATION
12.
Install Sportsonic
“
II Receiver (14), and set all coding switches per the installation and operating instructions provided with each
Sportsonic
“
II Transmitter. Connect plug (15) from height adjuster to receiver. Connect receiver to 3-prong twist-lock receptacle
(17). See Diagram Below.
13.
CHECK HEIGHT ADJUSTMENT OPERATION – In order to test operation of height adjuster, use a temporary hook-up, or test
after unit has been connected to the Sportsonic
“
II Receiver per the diagram below. Operate unit down to the 8'-0" goal height,
then back up to 10'-0".
NOTE – All wiring between the height adjuster and the Sportsonic
“
II Receiver is to be done by an electrical contractor per the
diagram below, to meet all local code requirements.
14. Give the Sportsonic
“
II Transmitter and this instruction booklet to the customer. Demonstrate the operation of the unit. Make the
customer aware of the Cautions, the Warnings, and the Maintenance requirements listed on Page 16 and 17.
IMPORTANT NOTE - PERFORMANCE OF MOTOR IS BASED ON HAVING 115 VOLTS AT MOTOR TERMINALS.
VOLTAGES LESS THAN 115 VOLTS WILL AFFECT HOISTING CAPACITY AND RESULT IN DAMAGE TO MOTOR, THUS
VOIDING WARRANTY.
FIELD WRING FROM
HEIGHT ADJUSTMENT UNIT
ELECTRICIAN NOTE - IF HEIGHT ADJUSTER OPERATION
DOES NOT CORRESPOND TO UP and DOWN BUTTONS
ON TRANSMITTER, REVERSE BLACK AND RED WIRES.
RED (DO
W
N)
GREEN/GROUND
BLACK (UP)
Y X G W
WHITE
SPORTSONIC
£
II
Gymnasium
Control System
NEXT PREV.
LOWER
RAISE
SPORTSONIC
£
II RECEIVER BOX
TO BE MOUNTED ON BACKSTOP
SUPERSTRUCTURE, WALL, ETC.
BY INSTALLER
ELECTRICAL CONTRACTOR
TO PROVIDE 4" SQUARE
BOX FOR POWER SOURCE
GREEN/GROUND
POWER SOURCE
SINGLE PHASE
MINIMUM WIRE SIZE
90' MAXIMUM RUN
90' to 140' RUN
OVER 140'
- 8 GA.
- 10 GA.
- 12 GA.
115 VOLT,
60 HERTZ
HOT LINE
WHITE
CONNECT WIRE FROM
JUNCTION BOX TO PLUG AS
FOLLOWS:
X - BLACK
Y - RED
W - WHITE
G - GREEN
TO JU
NC
TION
B
O
X
ON
HEIGHT ADJUSTER FRAME
ELECTRICAL CONTRACTOR TO PROVIDE
FIELD WIRING AS REQUIRED TO MEET ALL
LOCAL ELECTRICAL CODES.
NOTE