10
9'-6''
9'
8'-6''
8'
Detail
"E"
ADJUST FOUR
NYLON BOLTS AS
REQUIRED - SEE
STEP No. 9
ATTACHMENT OF HEIGHT ADJUSTER TO BACKSTOP MAST
6.
Hoist entire height adjustment assembly into position on the 2-3/8" O.D. drop tubes. See Detail "C". Secure to 2-3/8" O.D. drop
tubes with the tubes and hardware provided with the height adjustment unit.
10'-0"
3'-8
1
4
"
Detail "D"
7.
Attach goal to backboard and height adjustment Center-Strut
with
hardware provided with the goal. Check goal with level before
tightening the four bolts. See Detail "D".
8.
CHECK FOR 10'-0" GOAL HEIGHT:
For operation with Key Switch, Sportsonic
®
II, or Powr-Touch
®
keypad, use temporary electrical hook-up as required (see
appropriate wiring diagram) to raise height adjustment unit to the
highest position (bottomed out on the upper angle).
For operation with Powr-Stick, use the Powr-Stick to raise height
adjustment unit to the highest position (bottomed out on the upper
angle). See Detail "F" on Pg. 13 for proper use of the Powr-Stick.
With the height adjustment unit raised to its highest position, check
the 10'-0" goal height. Move height adjustment unit up or down on
the 2-3/8" O.D. drop tubes as required to acquire the 10'-0" goal
height.
9.
For manual height adjusters, CHECK HEIGHT ADJUSTMENT
OPERATION – Crank unit down to the 8’-0” goal height, then back
up to 10’-0” using the height adjustment crank provided. (NOTE –
One crank is provided with each pair of height adjustment units.)
10.
Install the four 3/8" x 1/2" lg. nylon bolts into the four flat nuts on
the height adjustment frame slide mechanism. The four nylon bolts
may be adjusted to maximum backboard stability if required – Caution, over-tightening these nylon bolts could create undue
friction and strain on the electric motor or make the unit more difficult to operate with the hand crank. See Detail "E".
