PORSCHE DESIGN Bike RS, Руководство пользователя

Страница: 29 / 43

!
i
56 57
Check whether you are still able to safely reach
the ground from the seat. If this is not the case,
you should at least set the seat lower until you feel
comfortable with your bike. Now push the seat into the desired position to the front
or back. Pay attention to the marks on the seat rails
and do not move the seat past them.
Position the seat so that it is levelled. You can use a
level for this.
Now tighten the seat clamping screws again with
a torque wrench. The seat should not turn in the
process. Check to make sure that the seat is secure
by attempting to pull it up and down
You can set the seat incline and seat position in
addition to the seat height. By adjusting the seat
position, you change the distance to the handlebars
and your pedalling position above the pedal crank.
The seat incline should be as levelled as possible so
that the cyclist is able to pedal comfortably without
slipping off the seat.
To adjust your seat, loosen the seat clamping
screw[ s ]. Only open the screws by turning them a few
revolutions, otherwise the seat clamping mechanism
could fail. The seat can now be adjusted both length-
wise along the carriage and in its incline.
Adjusting the bike to the user
Maximum pull-out length of the seat post.
If the seat post is pulled out past the maximum
pull-out length [ mark on the seat post or frame ], the
frame or the seat post may break and cause a crash
or accident. Observe the maximum pull-out length for
the seat post.
Check the screwed connections regularly with a torque
wrench as described in this owner’s manual and/or in
accordance with the manufacturer’s instructions. Only
clamp the straight sections of the seat frame. Observe
the marks on the tracks. Use special carbon fitting
lubricant on carbon frames.
INFORMATION
WARNING