Pontec MultiClear 5000, Руководство по эксплуатации

Страница: 9 / 22

- EN -
9
Assembly
The parts included in the scope of delivery are inside the container and have to be removed first!
How to proceed:
5
B
1. Undo the fasteners on both sides of the container cover and lift off the container cover.
2. Take out the UVC clarifying unit. (
à
Cleaning the UVC clarifying unit)
3. Screw the stepped hose adapter including sealing ring onto the UVC inlet.
4. Screw the inlet elbow including sealing ring onto the UVC outlet.
5. Place the UVC water housing onto the container cover and fasten with both screws, washers and nuts.
– Insert the screws through the guides on the UVC water housing and the holes in the container cover.
6. Place the container cover onto the container and carefully press down until the fasteners engage.
7. Fit the UVC clarifying unit. (
à
Cleaning the UVC clarifying unit)
Installation and connection
•
Do not expose the unit to direct sunlight.
– Maximum ambient temperature: 40 °C.
How to proceed:
5
C
1. Place the filter container in a flood protected position on firm and level ground at least 2 m from the edge of the
pond.
– Ensure that the outlet is not more than 1 m above the surface of the pond.
– Ensure that the unit is easily accessible for maintenance and cleaning.
2. Connect the hose to the UVC clarifying unit (stepped hose adapter at the inlet) and to the filter pump (stepped hose
adapter at the outlet).
3. Connect e.g. an HT pipe (DN 50) or a 2" hose with a hose clip to the filter container outlet.
Commissioning/start-up
W A R N I N G
Possible death or severe injury from hazardous electrical voltage!
•
Prior to reaching into the water, isolate (switch off and disconnect) all units/devices used in the water.
•
Isolate the device (disconnect from the power supply) before carrying out any work on it.
How to proceed:
5
D
•
First switch on the pump, then the UVC clarifier.
– The UVC clarifying unit is designed to be operated with water passing through it. Never operate the unit without
water.
•
Switching on: Insert the power plug into the socket.
– The unit switches on immediately.
– The control lamp is lit.
•
Check all connections for leaks.
•
Switching off: Disconnect the power plug.