WAT E R G A R D E N I N G T O T H E M A X
SKIMMER & WATER
FEATURE PUMPS
Turn the Front Filter Screen in the direction as indicated by the arrow, then pull away from Pump Motor Body.
Locate snap-fit release under Base Plate using the arrows above. Using your thumb, apply pressure and unclip Base
Plate until it releases from Pump Motor Body.
Remove Base Plate by pulling away from pump motor in the direction of arrow above.
To remove the impeller of the pump, turn the Impeller Cover Housing in an counterclockwise direction as indicated
by the arrow above, to the stop position. Then separate the Impeller cover from the Pump Motor Body.
With one hand gripping the Pump Motor Body, secure grip of other hand tightly on the fins of the Impeller and pull
out the Impeller assembly (take care not to break ceramic shaft.) The black disc behind the fins of Impeller is part
of the Impeller assembly. Clean the Impeller with water and vinegar and a suitable brush taking note to remove fine
sediment on and around the back end of the Impeller, the small hole through the ceramic shaft and the chamber the
Impeller fits into on the Pump Motor Body. (Always inspect the Impeller and replace the Impeller if it seems
necessary.)
Ensure to replace the O’ring as shown above when reinstalling the Impeller.
(See “IMPORTANT NOTES” section below for reassembly instructions)
IMPORTANT NOTES
• It is important that this procedure is carried out
regularly as the cooling path inside the motor can
become clogged. If the impeller assembly becomes
worn or damaged it should be replaced (available from
your dealer). Failure to do so may cause serious
damage to pump. Inspect for signs for wear and tear.
The impeller set is a wearable part.
• Once the cleaning and inspection process is
completed, reassemble in the reverses manner.
Reinstall the impeller into the motor body.
To place the Impeller O’ring around the black disc
successfully, firmly hold the disc with one hand, and
using the other hand stretch the O’ring over the disc,
positioning it carefully into the groove. Pay attention
not to allow the O’ring to roll forward, in-between the
black disc and the Pump Motor Body.
With the impeller in the correct position, carefully
place the Impeller Cover Housing on, and then rotate
clockwise back into position.
• If applicable re-insert the internal Sponge back into
the filter screen and re-attach to the pump. On other
models re-attach the Front Filter Screen.
• Now re-attach the Base Plate into position to lock
the impeller cover from turning.
Содержание 22EV125
Страница 12: ...888 868 1185 info pondmax com ...