P O N D M A X . C O M
• Any damage to the equipment or unmerited operation
will bring dangers to the surrounding precincts. f there
is any damage of the equipment, it must not to be used.
The equipment should be placed out of reach of
children.
• For your own safety, disconnect from the power supply
before any maintenance. Always unplug the pump from
the power supply when not in use. Never pull the cable
to disconnect the plug from the power supply - grasp
the plug and pull to disconnect. If required, have a
qualified electrician install a weatherproof power supply
point near to the pond or water-feature (within the
cable length of the appliance).
• When used in submerged application, be sure the
equipment is completely in the water. The depth should
not be greater than 6.5Ft.
• Do not operate the pump if the appliance or any
components of the system, such as the power cable,
has been damaged. Check appliance for defects
regularly.
• For safety, plug the pump into an electrical outlet with
a (GCFI) Ground Fault Circuit Interrupter.
• To avoid an electric shock, do not attach the plug to the
power supply socket with wet hands. The drip loop
method should be used to prevent water from traveling
down the cable and onto the plug or power supply.
If the plug does get wet, do not unplug the cable.
Disconnect the circuit breaker that supplies power to
the power supply point. Then unplug and examine the
plug and power supply point for presence of water. If
the power point has become wet, you should consult an
electrician before using the power point again.
• Do not install or store the appliance where it will be
exposed to extreme hot or cold temperatures. Do not
use in water above 95°C.
• Do not cut the cable as this will result in voiding your
warranty.
• Care should be taken to arrange the power cable so
that it cannot be accidentally tripped over or pulled.
• Do not attempt to repair the electrical appliance
yourself. Return to an authorized service center or
place of purchase if a fault occurs, (regular
maintenance is not considered repair and is required by
user).
IMPORTANT SAFEGUARDS
Correct and safe use of the system requires strict compliance with the safety instructions. For
safety reasons, persons less than 16 years of age or persons that are not familiar with these
instructions should not use this equipment.
PRODUCT SPECIFIC SAFEGUARDS
• Do not operate the pump without water in your
plumbing at any time, permanent damage may occur.
• When used in submerged application, be sure the
equipment is completely in the water. The depth
should not be greater than 6.5Ft. If used externally, the
pump must have adequate flooded suction at all times.
• The pump is designed to be used inside skimmers,
directly in a pond or in any other fresh water features.
• The pump should only be used in clean water. Do not
use the pump in, or with, any chemicals such as a
solvent or gasoline.
• The PondMAX Skimmer & Water Feature Pumps are
cooled by water flowing through the inside of the
motor body. If the pump flow becomes restricted it will
overheat and could cause permanent damage. Large
tubing size is strongly recommended to deliver
adequate water flow to cool the pump.
• The pump needs to be cleaned regularly to prevent the
pump becoming blocked, thus causing the pump to
overheat and burn out. This is not a
event.
It is strongly recommended not to select a pump that is
too small for the job required. The flow rate through the
pump needs to be enough so that a half of the rated
max flow is kept running at all times.
P O N D M A X . C O M
Содержание 22EV125
Страница 12: ...888 868 1185 info pondmax com ...