10
Then click the button
Fertig stellen
to finish the installation of the software.
The installation of the driver software is now finished.
8.1.2 Installation of the programming software
Install the software by starting the
“Setup.exe“
application in the desired folder.
Follow the instructions on the screen.
Close the screen displays once the installation has ended.
After the installation of the programming software on the PC, the QAM 12 LAN can
be connected to the PC with the USB cable.
If USB access from the outside of the unit is not desired, the USB connection cable can be removed from the
circuit board. The cable must be inserted into the clamp so that it cannot get into contact with the circuit boards or
the power supply. Programming is thereafter only possible via LAN or the internal USB interface.
USB
If this notice is displayed:
Continue the installation
The software was
installed for the following
hardware
LAN
