A-8
A Optional Accessories
INFORMATION
Soiling on the protective window will taint the measurement results. Thus the
protective window has to be free of dirt and dust. Remove dust only with
compressed air from an air duster. Remove dirt with a lint-free cellulose cloth
and only use water-based or alcohol-based glass cleaner if necessary. Do not
use any acidic or ammoniacal detergents.
Figure A.6:
Protective window
A.4.2
Assembly
For transport, the protective window is protected by a protective cover on the
front side and with a plastic plate on the back side. To mount the protective
window, proceed as follows:
1. Remove the plastic plate from the back of the protective window by
undoing the two knurled screws (refer to the following figure, picture 1).
Keep the plastic plate in a safe place.
ATTENTION!
Thread damage caused by overtightening the screws!
If you tighten the screws too firmly, you could damage the thread.
» Only hand-tighten the screws.
» Hand-tighten means: Tighten the screw firmly so that it can not undo itself.
Do not use excessive force and avoid damaging the thread.
2. Fix the protective window on the front of the scanning head (using the two
knurled screws (refer to the following figure, picture 2).
3. Remove the protective cover from the front of the protective window by
undoing the knurled screws (refer to the following figure, picture 3). Keep
the protective cover in a safe place.
Содержание PSV-500-3D
