POLTI lecoaspira vaporetto FAV 20, Инструкция по эксплуатации

Страница: 44 / 124

Should the problems persist, contact an Authorised Polti Service Centre (see www.polti.com
for the up-to-date list) or Customer Services.
PROBLEM CAUSE SOLUTION
Steam is released from the
safety cap.
Damaged or missing seal.
Safety cap not screwed on
completely.
Contact an authorised service
centre.
Turn off the appliance, unplug it
from the mains and wait for it to
cool before screwing the cap
back on.
The safety cap spins freely. The boiler is pressurised. Never force the cap open,
whether the appliance is swit-
ched on or the boiler is switched
off and the appliance is discon-
nected from the mains.
Always wait for the boiler to
cool, opening the cap without
force.
Accessories are difficult to
assemble.
The seals produce friction.
The locknut is not in the
correct position.
Lubricate the seals with silicone
grease or Vaseline, or alternati-
vely with a small amount of ve-
getable oil.
Turn the locknut to the correct
position as indicated in Chapter
2.
Loss of steam or drops of wa-
ter between the connection
of the accessories.
The seals are damaged. Replace the seals, as indicated in
Chapter 18.
After vacuuming liquids, the
liquid vacuumed comes out
of the brush.
Liquid remains inside the
tubes.
Floor is still not dry.
Suck in air for a few seconds to
allow the transfer of the liquid to
the tank.
Repeat the vacuuming opera-
tion.
The appliance turns off while
using suction.
Water filter collector full
or
motor overheated.
Turn off anddisconnect the ap-
pliance from the mains. Empty
the dirt collector and clean it. If
the problem persists, turn off
and disconnect the appliance
from the mains and wait 60 mi-
nutes for it to cool.
IT
A
L
IA
N
O
E
N
G
L
IS
H
| 44 |
All manuals and user guides at all-guides.com