Polon-Alfa CDG 6000, Эксплуатационная и техническая документация

Страница: 28 / 31

28 ID-E364-001
8. Installation
8.1. Control panel fixation
The CDG 6000 control panel may be wall mounted using four rawplugs with diameter of 6mm (fig.
8.1.1),
Fig. 8.1.1 CDG 6000 control panel fixation
8.2. Input and output circuits connection terminals
The control panel modules are fitted with terminals for external installation wires connection. Both
surface-mounted and flush-mounted installation wires may be inserted into the control panel. They
are routed through separate circular holes with glands for electrical power network and for low-
voltage wires.
Mains power supply
Electrical block with designations L N is intended for 230V / 50Hz mains connection.
Back-up power supply
Two colour wires are intended for the batteries cluster connection. The red wire, connected with the
positive battery terminal, is protected with car fuse (19mm) and its value is provided in chapter 9.1.