Pollard Brothers Manufacturing 5504 N. Northwest Highway Chicago IL 60630
.
.
. .
phone
(773)763-6868
fax
(773)763-4466
toll free
(800) 551-5566
After top is in place, make sure bench is square and then, tighten all bolts,
starting with the stringer and tie rods.
[3]
7
Assemble Back Plate with ¾” form facing the rear to
Steel Top using (3) or (4) ¼” x 5/8” Round Head
Machine Screws, ¼” Hex Nuts, and ¼” Lock Washers.
TIGHTEN.
Assemble pair of End Plates to Top and
Back Plate using 6 - 1/4” x 5/8” Round Head Machine
Bolts, ¼” Hex Nuts, and 1/4” Lock Washers.
TIGHTEN.
Assemble under steel top
and behind back plate.
8
From either side of bench, slide Steel Top (with Back
and End Plates attached) on the back side of the
assembled Bench lining up the 4 - ½” dia. holes
pierced in the turned under flange with matching
holes in Bench Leg top. Use (4) 3/8” x 3/4” Hex Head
Machine Screws, 3/8” Hex Nuts, and 3/8” Split Lock
Washers.
HAND TIGHTEN ONLY.
Make sure Steel
Top is resting flush on the 1/8” x 1” rabbet that runs
along the length of the Wood Top. After aligning
Metal Top on top of Wood Top drill pilot holes
through the (6) or (7) 9/32” holes that are counter
sunk for the #8 x ¾” Wood Screws. Use a #30 or 1/8”
drill and go ½” deep. Insert screws and tighten.
9
Insert Drawer slide on drawer into the drawer slide
on the drawer cover. After inserting drawer, fully
close drawer to ensure drawer has locked.
10
Drawer Front
Attach Cylinder Lock to Drawer Front. Remove End
Screw, Cam, and 1/2” Hex Nut from Cylinder. Insert
Cylinder into lock hole and replace 1/2” Hex Nut,
Cam, and End Screw according to diagram. Attach
drawer handle with (2) 8/32“ x 3/8” Flat Head
Machine Screws and 8/32” nuts.
