12
5. One more time press “ENTER”, will show “A-33”, means the device of 33 zones.
6. Press “SETUP”, will show “d-01”, which is alarm duration time. “01”means alarm
duration of 1 second, maximum alarm duration of 3 seconds. Press “SETUP” can
adjust to 01, 02, 03 second.
7. Press “SELECT” entering Zone-Sensitivity-Level adjustment, will show “1L-xxx”.
(“1” means 1st zone, “L”means left side zones, “xxx” means zone sensitivity level.)
Press “SETUP” can reduce the zone sensitivity level, press “ENTER” can increase the
zone sensitivity level. The higher the “xxx”figure, the higher the sensitivity!
Example, adjust to “1L-365”, means the Left side 1st zone sensitivity level is 365, the
detectable metal object would be a coin or a smaller metal object.
Samely, press “SELECT” in turn, will show “2L-xxx”~“11L-xxx”, user can adjust the
left side 11 zone sensitivity level respectively.
8. Then press “SELECT”again, entering right side zone settings. Will show “1R-xxx”,
means right side first zone sensitivity level. Same as the “1L-XXX”zone sensitivity
level adjustment, user can adjust the right side 11 zone sensitivity level respectively.
9. Now “Left” & “Right”side Zone-Sensitivity-Level finish adjusting, press
“SELECT” entering whole Sensitivity-Level adjustment, will show “H-xxx”, means
Device whole Sensitivity-Level is “xxx”.
10. After all Sensitivity-Level finish adjustment, press “SELECT”, will show “AP”,
means entered Application Mode adjustment option. Press “ENTER” will show
“AP-1”, means “Application 1”, press “SETUP”can adjust the application. Then press
“SELECT” to confirm the selection. The higher the application code figure, the lower
the sensitivity! (!For user convenient operation, we have particularly simplified the
Application to 6 total, which could meet all general markets requirements!)
11, Press “SELECT”, enter Volume-Level adjustment, and press “SETUP”
show“yL-H”, means high volume, press “SETUP”again, show “yL-L”means low
volume.
12. Press “SELECT”, will show “Id-xx”, means entered Device “ID”adjustment
option, “xx”means the device ID code. (Press “ENTER”for one time can add “1” in
single digits, press “SETUP”for one time can add “1” in 10-digit. Press
“ENTER””SETUP”for more times will add more respectively!)
13. Press “SELECT”, will show “A33”. Press “ENTER” then come to “Inspection
Mode” and device ready to work.
14. The device will automatically display PASS COUNT & ALARM COUNT, the
number of memories is 99999, press “RESET”can recount.
