P. 8
User Guide
LCD Transmitter Operation (Second Car Control)
Basic Vehicle Operation
FUNCTION
BUTTON PRESS
ICON
BUZZER
DESCRIPTION
LOCK
+
1 Beep
Locks the doors
and arms the Starter Kill (if
installed) and the alarm.
UNLOCK
+
2 Beep
Unlocks the doors and disarms
the Starter Kill (if installed) and
the alarm.
START
+
+
Melody
Starts the engine
STOP
+
None
Melody
Stops the engine
Start and Stop While in Safe Start Mode
FUNCTION
BUTTON PRESS
ICON
BUZZER
DESCRIPTION
START ON SAFE
START MODE
+
X 2
+
Melody
Press the
and buttons
simultaneously
twice
within
3 seconds.
Press for 1 second (a melody
will be heard) then press 1sec
and a melody will be heard
again.
STOP ON SAFE
START MODE
+
None
Melody
Remote-Starting Your Vehicle
Remote-starting
Press the
START/STOP
button for approx. 1 second. The parking lights will come
O N
and the remote
control will play a melody to inform you that the System has received your signal. Approximately 5
seconds later, the engine will start. The parking lights will remain
ON
during the pre-programmed
run time of the engine.
If the vehicle does not start at the first attempt, the system will shut down, wait a few seconds and
try to start the engine again. There will be 3 start attempts before the system gives up.
Vehicle Presets
Heater & Heated Seat
When leaving the vehicle it is recommended to preset the accessory controls in preparation for the
next remote start. Settings for the blower motor (fan), front and rear, as well as heated seats (if
equipped) should not be left on
HIGH
. It is recommended to leave the settings on
LOW
or
MEDIUM
instead.
Windshield Wipers & Radio & Headlights
Certain vehicles require the radio and / or windshield wiper and / or headlight circuits to become
energized while running under remote start. When leaving the vehicle you must ensure that the
windshield wiper and headlight switches are
OFF
. Leaving the headlight switch
ON
on certain types
of vehicles could cause them to remain
ON
even after remote starter shut down, resulting in a dead
battery.
Driving Off
With the vehicle running under remote control, press the
UNLOCK
button to disarm and unlock the
doors. Enter the vehicle and do the following:
