Polaroid M402b, Руководство по ремонту

Страница: 10 / 42

M402b MiniPortrait Camera Repair Manual Disassembly/Assembly
10
5. Gently lift off the front cover being careful not to disturb the alignment of the shutter plates.
Note: If the shutter and the diaphragm plates are misaligned during the removal
of the front cover, refer to the Shutter and Diaphragm Plate
assembly/disassembly procedure to properly realign (see page 24).
6. Disconnect the black and red X-sync connections from the shutter plate connector pins.
Figure 2-1. Removing front cover assembly
Installation
1. Connect the black and red X-sync connections from the front cover to the shutter plate
connector pins.
Note: Make sure the red and black X-sync wires are properly dressed so that they
do not interfere with the operation of the shutter.
2. Gently position the front cover onto the shutter plate being careful not to disturb the
alignment of the shutter plates.
Note: If the shutter and the diaphragm plates are misaligned during the installation
of the front cover, refer to the Shutter and Diaphragm Plate
assembly/disassembly procedure to properly realign (see page 24).
Rear View of Front Cover
Lens Cap
Aperture Knob
Front Cover
Assembly
Camera
Body
Lower Decal
Cover
Upper Decal
Cover
Shutter Plate
Assembly
CAUTION
When installing the front cover make sure:
• the four (4) fine thread screws are used to
secure the top of the front cover/shutter
plate assembly to the camera body.
• the two (2) coarse thread screws are used to
secure the bottom of the front cover/shutter
plate assembly to the camera body.