Polaroid Joshua Captiva, Руководство по обслуживанию

Страница: 121 / 134

5 - 13
Note: The Flex Extension Ribbon Cable and corresponding connectors have
6 conductors on one side of the locating hole/pin and 7 conductors
on the other side. Observe this pattern when making connections.
10. Using a square drive tool, remove the screws holding the Front Panel (Figure 4-4), then gently pry off
the Front Panel using a greenstick.
11. Now insert a modified Q Tip between the top of the Erect Sensor and the Mainframe, as shown in the
inset at the right in Figure 5-5, to hold the Sensor down and maintain power to the Camera.
12. If Camera operation with the new Shutter Assembly still exhibits the same problem, look for the cause
of the problem in the Mainframe.
If the problem no longer occurs with the new Shutter Assembly connected, replace the original Shutter
Assembly.
Figure 5-5. Connecting a known, good Shutter Assembly in place of Camera Shutter Assembly
KNOWN GOOD
SHUTTER ASSEMBLY
EXTENSION CABLE
P/N 13562
DISCONNECT FLEX
FROM SHUTTER
Q TIP CUT 2" LONG
HEAD WRAPPED
WITH SCOTCH TAPE
FLEX
CAP
6 CONNECTORS
7 CONNECTORS