Instr 9927475
Rev 01 2017-02
Page 8 of 14
WIRELESS REMOTE HOLDER INSTALLATION
1. Wireless remote holder can be installed in desired
location on vehicle. Use the screws provided in the
wireless remote kit for holder installation. For your
reference see the photo below for possible
mounting location of wireless remote holder.
FINAL INSPECTION
1. Confirm that all wiring is correct.
2. Confirm that there are no exposed wires or
terminals.
3. All loose wires need to be wrapped tight, and
secured away from moving parts and heat
sources.
REINSTALLATION
1. Reinstall the lower front bumper cover
J
. If you
plan to use a plow, do not reinstall winch cover
L
.
If you do not plan to use a plow, reinstall winch
cover
L
.
2. Reinstall accessory front brushguard (if equipped).
3. Reconnect battery red (positive) and black
(negative) cables to battery terminals at this time.
4. Reinstall the front cover
E
using retained
screws
D
.
5. Close the front rack
A
and secure in place using
rubber latches
B
.
6. With the vehicle key in the ON position, check
winch for proper operation.
Test function of Autostop feature. When reeling in
the winch rope, confirm that the winch will turn off
automatically when the rubber puck reaches the
aluminum fairlead. The winch should not allow the
rope to be reeled in once the rubber puck has
come within a close proximity (typically 1” or less)
or made contact to the fairlead. If the Autostop is
not functioning properly, see troubleshooting
information at the end of the instructions.
