Instr 9927475
Rev 01 2017-02
Page 6 of 14
4. Route red (positive)
f
and black (negative)
d
winch cables on the side of the radiator then
behind it to reach the three terminal bus bar as
shown.
DO NOT CONNECT TO THE WINCH
CABLES TO THE BUS BAR AT THIS TIME.
CONTROL BOX INSTALLATION
1. Position control box
w
on the right side of the
vehicle behind the radiator as seen in the photo
below. Connect white electrical connectors for the
control box as seen in the top photo of the
Electrical Connections Reference Guide section of
the instruction manual.
2. Route power wires to battery area and connect red
or orange wire from control box to orange wire on
the vehicle’s main wire harness as seen below.
Route black wires from control box
w
to black
(ground) terminal area near the bus bar.
DO NOT
CONNECT TO THE BUS BAR AT THIS TIME.
WIRELESS REMOTE RECEIVER INSTALLATION
1. Install wireless remote box
e
onto cab support
bracket
Q
using cable ties as shown.
