Polaris Ranger 500 2x4 2007, Руководство по обслуживанию, Страница: 256 / 345

8.12
TRANSMISSION
16. Carefully install the shaft assembly and gear cluster as a
unit into their respective bearing case recesses. Tap with a
soft face hammer to seat shaft assemblies.
17. Position the shift forks up and so the pins point toward the
9 o’clock position, before installing the shift drum
assembly.
18. Replace and grease the O-ring’s on the shift drum before
installation.
19. Install the shift drum into the case.
NOTE: Make sure shift shaft pins are properly
positioned in the slot on selector arms.
20. Lift the shift rail slightly and rotate the rail/fork assembly
so it meshes with the tracks on the shift drum. Be sure the
wave springs are properly in place and that the shift rail is
seated into the pocket on the backside of the case.
21. Install the helical gear and bearing onto the pinion shaft.
22. Clean the mating surfaces of the case and cover. Apply
Crankcase Sealant (PN 2871557) to the mating surfaces. Be
sure the locating pins (knock pipes) are in place. Reinstall
cover and torque bolts in a criss-cross pattern in 3 steps to
27-34 ft. lbs. (37-46 Nm).
23. Reinstall the mounting bracket if previously removed.
24. Grease the seal lips of the input shaft seal. Apply
electricians tape or somehow cover the splines of the shaft
to protect the seal lips during installation. Install new input
shaft seal.
Front Cover Bolt Torque:
27-34 ft. lbs. (37-46 Nm)